ACT ACTENTRY V-IP Manual de instalación

ACTentry V-IP Operating & Installation Instructions 18-00082 Rev 3.1 I

ACTentry V-IP Operating and Installation Manual Page 9 2. Surface mount Surface Mount Box Front Panel  The surf

ACTentry V-IP Operating and Installation Manual Page 10 2.3 Installing the ACTentry V-IP Unit Please follow the guidelines below when installing

ACTentry V-IP Operating and Installation Manual Page 11 1. When the red LINK LED and the green TX/RX LED flash slowly (about once per second)

ACTentry V-IP Operating and Installation Manual Page 12 2.7 ACTentry V-IP software installation The V-IP unit needs to be powered up and connec

ACTentry V-IP Operating and Installation Manual Page 13 A list of available ACTentry V-IP units on the network (LAN) will be displayed. e. “Ti

ACTentry V-IP Operating and Installation Manual Page 14 2.9 Configure Settings a. Click Setup button to configure the settings for the selecte

ACTentry V-IP Operating and Installation Manual Page 15 Door Name: This is the name that will appear on the application and in reports. By de

ACTentry V-IP Operating and Installation Manual Page 16 b. Click on Audio Tab to configure the Audio settings in the PC. To help configure t

ACTentry V-IP Operating and Installation Manual Page 17 3.0 OPERATION When the call button at the ACTentry V-IP entry panel is press

ACTentry V-IP Operating and Installation Manual Page 18 4.0 TROUBLESHOOTING 4.1 No V-IPs found on the network Check that all V-IP units ar

Rev 3.1 Issue 1 This manual refers to ACTentry V-IP, a TCP/IP based door videophone system. Access Control Technology Ltd. reserve the

ACTentry V-IP Operating and Installation Manual Page 19 4.2 Audio Feedback is heard by PC user when connected to live video Lift the ACT Hand

ACTentry V-IP Operating and Installation Manual Page 20 4.4 The person at the door cannot hear PC User Increase the Microphone sensitivity in

ACTentry V-IP Operating and Installation Manual Page 21 4.5 Video picture is poor quality or grainy The bandwidth can be increased. Go t

ACTentry V-IP Operating and Installation Manual Page 22 5.0 SETTING A FIXED IP ADDRESS By default the V-IP unit is supplied with support for DHC

ACTentry V-IP Operating and Installation Manual Page 23 If the V-IP unit does not have a known IP address, then it can be set to a default

ACTentry V-IP Operating and Installation Manual Page 24 6.0 ACTentry V-IP panel Mount Installation Diagram

ACTentry V-IP Operating and Installation Manual Page 25 7.0 Installation Notice for Flush mount units.

ACTentry V-IP Operating and Installation Manual Page 26 8.0 Mounting instructions for Extended Version of ACTentry V-IP. The ACTentry V-IP doo

ACTentry V-IP Operating and Installation Manual Page 27  The flush-mount version comprises of two parts: 1. Flush mount back box 2. Flush

ACTentry V-IP Operating and Installation Manual Page 28 8.2 ACTentry V-IP SPX – Surface mount panel with cut out for panel mount reader

ACTentry V-IP Operating and Installation Manual Page 2 Table of Contents Table of Contents ...

ACTentry V-IP Operating and Installation Manual Page 29 Ordering Information: ACT Product Code Product descriptionACTentry V-IP SK Surface M

ACTentry V-IP Operating and Installation Manual Page 3 Ordering Information ACT Product Code Product descriptionACTentry V-IP SK Surface Mo

ACTentry V-IP Operating and Installation Manual Page 4 1.0 INTRODUCTION 1.1 System Overview The ACTentry V-IP (Video/audio over IP) syst

ACTentry V-IP Operating and Installation Manual Page 5 2.0 INSTALLATION 2.1 System Requirements The minimum PC requirements are: 1. Colour SVGA

ACTentry V-IP Operating and Installation Manual Page 6 2.2 Installing ACTentry V-IP door panel

ACTentry V-IP Operating and Installation Manual Page 7 The ACTentry V-IP door panel is available in Flush-mount or Surface-Mount versions. 1.

ACTentry V-IP Operating and Installation Manual Page 8  The flush-mount version comprises of two parts: 1. Flush mount back box 2. Flush mo